UDO AUDIO SUPER 6 Owner's Manual page 39

NAVIGATION
IMPORTANT SAFETY
INSTRUCTIONS
ACKNOWLEDGEMENTS
INTRODUCTION
OVERVIEW
QUICK START
UPDATING THE FIRMWARE
CONNECTIONS
SOUND DESIGN &
PROGRAMMING
EFFECTS
PERFORMANCE CONTROL
SECTION (KEYBOARD
MODEL)
ADDITIONAL CONTROLS &
PARAMETERS (DESKTOP
MODEL)
USING THE MODULATION
MATRIX
VOICE ASSIGN
ARPEGGIATOR &
SEQUENCER
GLOBAL SETTINGS
MPE SUPPORT
FILE MANAGEMENT
HOW-TO GUIDE
CHEAT SHEET
MIDI SPECIFICATIONS
GLOSSARY
SUPPORT INFORMATION
When DDS 2 is set to X-FADE mode (see page 33), you can use the MIX
control to set the split point on the keyboard relative to which the audio
signals from DDS 1 and DDS 2 or DDS 1 and an external source are
crossfaded.
At a 12 o'clock setting the split point is set to middle C (C4). Since the
crossfade between the signal of both oscillators covers an interval of two
octaves, the crossfade ranges from C3 to C5 at this setting.
The further you turn the MIX control counterclockwise, the further the split
point will move down to the left half of the keyboard. Likewise, turning the
MIX control clockwise will move the split point up to the right half of the
keyboard.
Amplitude
DDS 1
1.0
C2
Crossfading the signals from DDS 1 and DDS 2 across the keyboard.
Since there are six pairs of VCAs for the mixer, binaural mode is
always be enabled when you select X-FADE mode.
UDO Super 6 — Owner's Manual
Split Point
C3 C4
DDS 2
C5 C6
Key
39