UDO AUDIO SUPER 6 Owner's Manual page 58

NAVIGATION
IMPORTANT SAFETY
INSTRUCTIONS
ACKNOWLEDGEMENTS
INTRODUCTION
OVERVIEW
QUICK START
UPDATING THE FIRMWARE
CONNECTIONS
SOUND DESIGN &
PROGRAMMING
EFFECTS
PERFORMANCE CONTROL
SECTION (KEYBOARD
MODEL)
ADDITIONAL CONTROLS &
PARAMETERS (DESKTOP
MODEL)
USING THE MODULATION
MATRIX
VOICE ASSIGN
ARPEGGIATOR &
SEQUENCER
GLOBAL SETTINGS
MPE SUPPORT
FILE MANAGEMENT
HOW-TO GUIDE
CHEAT SHEET
MIDI SPECIFICATIONS
GLOSSARY
SUPPORT INFORMATION
The left-right phase when LR PHASE is set to 100% (2π).
PAN: When binaural mode is disabled, the LR PHASE fader turns into
a pan spread control, allowing you to adjust how far the non-binaural
voices are spread in the stereo panorama. At its lowest setting, all voices
are almost centred. At its highest setting, all voices are alternately hard-
panned between the left and right channels.
WAVEFORM: In low-frequency mode, this rotary switch allows you
to choose from four different waveforms: triangle, square, random or
sawtooth.
LFO 1 waveforms.
• Triangle can be used to produce vibrato effects as it alternates equally
between positive and negative values. This is a bipolar waveform.
• Square and sawtooth generate positive values that allow for pulsating
sounds or modulations. The square wave can also be used to create
trill-like effects at higher rates.
• Random produces random positive or negative values for the duration
of one duty cycle. This waveform can be used to create either subtle
movements or wild effects. With RATE set to its highest value, sample
& hold will generate a white noise signal.
• HF: Selecting this option enables high-frequency mode, which allows
for rates between 20 Hz and 20 kHz. In this mode, LFO 1 can be used
either as a drone or as a constant modulation source for audio rate
modulation. By default, LFO 1 is set to a sine wave in this mode.
UDO Super 6 — Owner's Manual 58