Table of Contents
Advertisement
NAVIGATION
IMPORTANT SAFETY
INSTRUCTIONS
ACKNOWLEDGEMENTS
INTRODUCTION
OVERVIEW
QUICK START
UPDATING THE FIRMWARE
CONNECTIONS
SOUND DESIGN &
PROGRAMMING
EFFECTS
PERFORMANCE CONTROL
SECTION (KEYBOARD
MODEL)
ADDITIONAL CONTROLS &
PARAMETERS (DESKTOP
MODEL)
USING THE MODULATION
MATRIX
VOICE ASSIGN
ARPEGGIATOR &
SEQUENCER
GLOBAL SETTINGS
MPE SUPPORT
FILE MANAGEMENT
HOW-TO GUIDE
CHEAT SHEET
MIDI SPECIFICATIONS
GLOSSARY
SUPPORT INFORMATION
The cross modulation fader in the DDS Modulator section.
CROSS MOD: This fader controls the amount of cross modulation. By
default, DDS 2 modulates DDS 1 with exponential FM. Use this parameter
to create complex or bell-like timbres.
Enabling hard sync reverses the default cross modulation routing,
resulting in DDS 2 being frequency modulated by DDS 1. Since in
this case DDS 2 is forced to restart its duty cycle with DDS 1 while
DDS 1 is responsible for the fundamental frequency, any changes
applied to DDS 2 will alter the harmonic content of the sound, the
depth of which is controlled with the CROSS MOD fader. This
allows for results similar to wave folding or phase modulation.
UDO Super 6 — Owner's Manual
64
Advertisement
Table of Contents
