UDO AUDIO SUPER 6 Owner's Manual page 63

NAVIGATION
IMPORTANT SAFETY
INSTRUCTIONS
ACKNOWLEDGEMENTS
INTRODUCTION
OVERVIEW
QUICK START
UPDATING THE FIRMWARE
CONNECTIONS
SOUND DESIGN &
PROGRAMMING
EFFECTS
PERFORMANCE CONTROL
SECTION (KEYBOARD
MODEL)
ADDITIONAL CONTROLS &
PARAMETERS (DESKTOP
MODEL)
USING THE MODULATION
MATRIX
VOICE ASSIGN
ARPEGGIATOR &
SEQUENCER
GLOBAL SETTINGS
MPE SUPPORT
FILE MANAGEMENT
HOW-TO GUIDE
CHEAT SHEET
MIDI SPECIFICATIONS
GLOSSARY
SUPPORT INFORMATION
DDS 1's centroid oscillator and its six sister oscillators spread to both sides when super mode is
enabled at full depth and the detune parameter is set to 100%.
PW/DETUNE: This fader controls the pulse width of DDS 2's pulse wave.
With super mode enabled, this fader also controls the amount of detune
spread applied to DDS 1. Increasing the amount noticeably thickens the
sound of DDS 1 as stacked versions of the same waveform are detuned.
DRIFT: In shift mode, the PW/DETUNE fader controls the amount of
randomisation applied to various parameters, including the pitch of the
oscillators, filters and envelopes, among others. Use DRIFT to either add a
pleasing amount of oscillator movement or to achieve extreme detuning.
PWM/SWM: This fader controls the amount of pulse width modulation
(PWM) applied to DDS 2's pulse wave. If super mode is engaged, this
fader also controls the amount of super wave modulation (SWM). Super
wave modulation determines how much modulation depth is applied to
the DDS 1 detune spread modulation.
The toggle switch to the right allows you to select the modulation source
for pulse width modulation (PWM) and super modulation (SWM):
• LFO 1: With this setting, LFO 1 acts as the modulation source.
• BOTH: With this setting, LFO 1 and ENV 1 act as the modulation
sources.
• ENV 1: With this setting, envelope 1 acts as the modulation source.
UDO Super 6 — Owner's Manual
Amplitude
0
Frequency
63