Table of Contents
Advertisement
NAVIGATION
IMPORTANT SAFETY
INSTRUCTIONS
ACKNOWLEDGEMENTS
INTRODUCTION
OVERVIEW
QUICK START
UPDATING THE FIRMWARE
CONNECTIONS
SOUND DESIGN &
PROGRAMMING
EFFECTS
PERFORMANCE CONTROL
SECTION (KEYBOARD
MODEL)
ADDITIONAL CONTROLS &
PARAMETERS (DESKTOP
MODEL)
USING THE MODULATION
MATRIX
VOICE ASSIGN
ARPEGGIATOR &
SEQUENCER
GLOBAL SETTINGS
MPE SUPPORT
FILE MANAGEMENT
HOW-TO GUIDE
CHEAT SHEET
MIDI SPECIFICATIONS
GLOSSARY
SUPPORT INFORMATION
If you want to edit or re-record a step, simply press the
corresponding step button. Its LED will start flashing, indicating that
the sequencer is now waiting for you to play a new note or chord.
Once you've done so, the LED will stop flashing and the sequencer
will advance to the next step.
• SLIDE: This track allows you to specify which steps are tied together.
When portamento is set to a non-zero value, a pitch slide occurs
between tied notes of different pitches. To tie steps together, press
adjacent step buttons. For example, if you would like to tie steps 3 and
4 together, press buttons 3 and 4 while on page 1 of the sequence.
Active ties are indicated by lit LEDs.
• ACCENT: This track allows you to specify which steps should be
accented. With accents you can emphasise the level and brightness
of notes or chords if the DYNAMICS switch in the VCA section is set
to either 1/2 or ON. This is useful for adding dynamic variety to your
sequence. Active accents are indicated by lit LEDs.
• REST: This track allows you to specify which steps to omit. An active
rest causes the note or chord you recorded to that step to be skipped.
Active rests are indicated by unlit LEDs.
• LENGTH: This track allows you to define the length of a sequence.
First use the RANGE button to select the page on which the last step
of the sequence should be. Then press the button corresponding to the
step you wish to be the last step in the sequence. For example, if you
would like your sequence to be eight steps long, make sure you are
on page 1 and then press button 8. To indicate active steps, the LED
representing the last step in the sequence and all steps before it light
up. After the last step is triggered, the sequence starts over.
When you're in recording mode and TRACK is set to STEP, you
can also record the position of the bender as you play notes.
When the sequencer is switched on and SEQ REC is flashing, you
can use the remaining voices, i.e. the voices not used for the current
sequence, to play along with the sequence.
HOLD: If you activate this function, the sequence can be transposed
according to the notes you play. Transposition is relative to middle C
(C4). For example, if you play a note above middle C, the sequence is
transposed above middle C by this interval.
UDO Super 6 — Owner's Manual
100
Advertisement
Table of Contents
