UDO AUDIO SUPER 6 Owner's Manual page 25

NAVIGATION
IMPORTANT SAFETY
INSTRUCTIONS
ACKNOWLEDGEMENTS
INTRODUCTION
OVERVIEW
QUICK START
UPDATING THE FIRMWARE
CONNECTIONS
SOUND DESIGN &
PROGRAMMING
EFFECTS
PERFORMANCE CONTROL
SECTION (KEYBOARD
MODEL)
ADDITIONAL CONTROLS &
PARAMETERS (DESKTOP
MODEL)
USING THE MODULATION
MATRIX
VOICE ASSIGN
ARPEGGIATOR &
SEQUENCER
GLOBAL SETTINGS
MPE SUPPORT
FILE MANAGEMENT
HOW-TO GUIDE
CHEAT SHEET
MIDI SPECIFICATIONS
GLOSSARY
SUPPORT INFORMATION
3. USB Port: Connect the Super 6 to your computer using the included
USB cable for bidirectional MIDI communication, patch, waveform and
sequence file management, and firmware updates. The Super 6 does not
require any drivers to interface with a computer.
4. MIDI In, Out and Thru Ports: Standard 5-pin MIDI DIN connectors.
5. Expression Pedal Input: Connect an expression pedal to this input to
add dynamics to your live performance. There are a variety of options for
using an expression pedal, since it is an assignable modulation source
in the Super 6's modulation matrix. This input accepts any standard
expression pedal that features a TRS (Tip-Ring-Sleeve) connector and
operates with a linear potentiometer over a range of 0 to +5 volts.
6. Sustain Pedal Input: Connect a footswitch to this input to sustain
notes during your performance. Upon power cycling, the Super 6 will
automatically detect the polarity of the connected pedal. Note that the
state of the sustain pedal at power-up is taken as its 'off' state.
7. Audio In: This input allows you to process an external audio signal. The
external audio signal will enter the signal path through the channel of DDS
2 before passing through the mixer, the analog filters, and the chorus and
delay effects. The audio input accepts a stereo 1/4 inch jack.
8. Main Audio Outputs (Left and Right): The Super 6 is capable of
gorgeous stereo sounds. Connect both outputs to your mixer or audio
interface using unbalanced 1/4 inch cables. If you only connect the left
output to your mixer or audio interface, the left and right signals will be
summed to mono. Refer to page 93 on how to achieve a true monaural
signal.
9. Headphone Output: Connect a 1/4 inch stereo headphone jack to this
output. The overall volume of the headphone output is controlled by the
MASTER VOLUME control.
UDO Super 6 — Owner's Manual
S6XXXXX
25