Appendix; Recommended Default Parameters Settings; Atlas Remote Ethernet Protocol - LACO Technologies ATLAS Operation And Maintenance Manual

Appendix

The ATLAS controller also runs a TCP/IP server to handle remote communication.
Connect an ethernet cable to the RJ45 port on the right side of the unit and using
a TCP Client terminal such as PuTTY or Hercules, connect to the ATLAS CPU IP
address (located in UniApps -> Network) on port 20263.
All send and reply commands end with a [CR]. All read commands start with a "?"
(ASCII 63) and request or set commands start with a "!" (ASCI 33) character.
LACO Technologies
NOTICE_
All as-shipped Advanced, Calibration and recommended Recipe settings will be identified
in the As-Shipped Parameter Summary.
Command Description
!CS Start Cycle
!CA Abort Cycle/
acknowledge fault
!MC or ?MC Change or View
Mode
?TC Test or Cycle
Complete
?SC Read current part
state & system
state
?SR Read last test part
result
?TS Read last test
result
ATLAS Operations and Maintenance Manual
Response Validity
CS Ready only with
no fault
CA In-cycle or fault
recovery
AUTO or CAL Ready only
YES or NO Test result data is
overwritten once
subsequent test is
complete.
TD-(Table2): All
(Table1)
SR-(Table 2) All
TS-(Date)-(Time)- Ready only when
(FinaILR)- (Test test completed.
result state)
9 APPENDIX
67