6 OPERATION
Clamp Config
Clamp Sensor
Clamp Timer
Safety Control
Part Present Sensor
Chamber Closed Sensor
Auto Start Cycle
6.5.2.5.
Chamber Vent Valve
Chamber Vent Press
Chamber Vent Fault Time
28
When equipped, there are four configurations for each pair of Clamps (1/2, 3/4)
•
Single Clamp
•
Dual Clamp
•
Extend/Retract
•
None
Single clamp uses only one clamp (clamp 1 or 3). Dual clamp uses both clamps in
the pair. Extent/ retract uses the first clamp in the pair (clamp 1 or clamp 3) to
extent, and the second clamp in the pair (clamp 2 or clamp 4) to retract.
Select if there is a sensor for the specified clamp.
Fault timer for the clamp.
Indicates that the system has safety control components (light curtains, emergency
stop switches, etc.)
Indicates that there is a part present sensor installed and connected to the ATLAS.
Indicates that there is a chamber door closed sensor installed and connected to the
ATLAS.
Select to automatically start a cycle when the chamber door is closed.
Chamber Settings
Select if a chamber vent valve is installed to the ATLAS.
Maximum pressure setpoint for the chamber vent pressure.
Time to vent the chamber before triggering a fault when the vent pressure does
not reach vent pressure setpoint.
ATLAS Operations and Maintenance Manual
LACO Technologies