Table of Contents
Advertisement
2 SAFETY
Safety
2
The ATLAS controller is designed to be used as a part of a leak test system to
control the test process and provide an operator interface. In this configuration, it
is dependent on other components (TITAN VERSA detector, tooling, etc.)
The ATLAS can also be used as a stand-alone controller for helium charge only
applications.
•
ATLAS may only be used for leak testing with the gases specified in Technical
Data,
section 4.3
•
You must install, operate and service this device only in compliance with these
operating instructions.
•
Adhere to the storage and usage recommendations.
NOTICE: Improper use will cause all claims for liabilities and warranties to
be forfeited.
Improper use is defined as usage for purposes deviating from the intended
uses stated above
•
Operate the device only when it is in technically perfect, working order.
•
Operate the device only as specified in a safety-conscious and hazard-
conscious manner, and in compliance with these operating instructions.
•
Adhere to the following regulations and monitor their compliance:
Intended use.
o
Safety and accident prevention regulations
o
International, national, and local standards and guidelines
o
Additional provisions and regulations that are specific to the unit Safety
o
conscious.
•
Use only original parts or parts approved by the manufacturer.
•
Keep these operating instructions available at the equipment location.
ATLAS Operations and Maintenance Manual
LACO Technologies
Advertisement
Table of Contents
