Intended Use; General Regulations For Careful Handling - SPX FLOW APV CU4 plus Instruction Manual

SPX FLOW
SPX FLOW_CU4.plus. 24V Direct Connect_IECEx_Zone 2_GB-1_012024_for D4. Valves.indd
Control Unit
CU4plus Direct Connect
Instruction Manual GB-0
2. Safety Instructions
2.2. Intended use
The CU4plus Direct Connect control unit is only intended for use as
described in chapter 3.1. Use beyond that described in chapter 3.1.
do not comply with the regulations and SPX FLOW shall not be
responsible for any damage resulting from this non-observance.
The operator bears the full risk. Prerequisites for proper and
safe operation of the control unit are the appropriate transport and
storing as well as the professional assembly. Intended use also
means the observance of operating, service and maintenance
conditions.
2.3. General regulations for careful handling
To ensure a faultless function of the unit and a long service life,
the information given in this instruction manual as well as the
operating conditions and permissible data specified in the data
sheets of the control unit for process valves should be strictly
adhered to.
- The operator is committed to operating the control unit in faultless
condition, only.
- Observe the general technical rules while using and operating the
unit.
- Observe the relevant accident prevention regulations, the
national rules of the user country as well as your company-internal
operating and safety regulations during operation and maintenance
of the unit.
- Switch off the electrical power supply before carrying out any work
on the system!
- Note that piping or valves that are under pressure must not be
removed from a system!
- Take suitable measures to prevent unintentional operation or
impermissible impairment.
- Following an interruption of the electrical or pneumatic supply,
ensure a defined and controlled re-start of the process!
- If these instructions are not observed, we will not accept any
liability. Warranties on units, devices and accessories will expire!
GB
11