Deleting "Delayed Start" - "No Demi" Settings - Smeg WD2145 User Manual

If the option is active, the message "no dE ", meaning "No demi", temporary disabling of demineralised water, appears
on the screen.
If the option is disabled by pressing the two keys mentioned above, the message "dE" is shown on the screen.
This option can only be used if the use of demineralised water has been activated.
(See parameter "7-Demineralised water" below in the setup parameters section, in the: SETUP MODE - "FUNCTIONS")
The disabling option can be activated before starting the selected program, and remains active
for only one cycle, at the end of which it is deactivated automatically.
When the disabling option is active, demi water is replaced with cold water in all the phases where
it would normally be used.
1
fig. 24 – Demi water disabling buttons. To access the function: hold down the Functions + Door opening buttons together. To select demi water
fig. 25 – Display screen: TEMPORARY disabling of demi water; the option can be enabled and disabled using the selection buttons

5.11.4 Deleting "Delayed start" - "No Demi" settings

To delete a setting:
1. return the parameter to zero (e.g. "dh:00" for delayed start, " dE" for demi water).
2. switch the device off and back on (the default value is restored: e.g. "dh:00").
3. open the door of the device (for "delayed start" only) once the cycle start command has been given.
User Manual
disabling: Selection buttons
WD2145-WD1160-WD4060-WD4190
2
Page 36 - 85
1