Clutch Maintenance; Air Filter Cleaning; Spark Plug Cleaning; Lubrication Of The Blade Rotor - P.Lindberg 9068995 Manual

CLUTCH MAINTENANCE

The centrifugal clutch on this machine is permanently lubricated and does not require oil or grease.
If the drum wobbles excessively after prolonged use, replace the drum.
CLUTCH REMOVAL
1. Remove the clutch from the shaft by removing the bolts and washers.
2. Slide the clutch off the shaft.
3. Remove the key from keyway.
INSTALLATION OF A NEW CLUTCH
1. Clean the shaft and remove any burrs.
2. Apply lubricant to the shaft.
3. Place the key in the keyway on the shaft.
4. Slide clutch onto shaft, secure with bolt, flat washer, and lock washer.
5. Tighten the two screws.

AIR FILTER CLEANING

A blocked air filter reduces the engine's performance significantly and leads to faulty engine
function. It also reduces the lifetime of the engine!
Remove the air filter cover. Remove the air filter. Clean the air filter. And drip some drops of oil
onto the filter. Replace the filter.

SPARK PLUG CLEANING

Remove the spark plug terminal from the spark plug. Loosen and remove the spark plug. Remove
carbon and deposits using a small brush. The electrode gap must be approximately 0.5–0.7 mm.

LUBRICATION OF THE BLADE ROTOR

Lubricate the blade rotor bearings on both sides using the
grease nipple. Also after every cleaning!
•
Remove the cover.
•
Wipe clean the lubrication nipple using a cloth.
•
Set the grease gun on the lubrication nipple and pump
grease into the nipple.
•
Re-fit the cover.
P. Lindberg A/S
Tlf: 70212626
30
Sdr. Ringvej 1
DK-6600 Vejen
MAN 9068995 EN V1
www.p-lindberg.dk
e-mail: salg@p-lindberg.dk