Operation - P.Lindberg 9068995 Manual

OPERATION

•
At engine start-up, the engine of your chipper operates under no load at 3,600 RPM until
approximately 1,200 – 1,400 RPM's at which speed the centrifugal clutch engages and begins
driving the rotor.
•
Rotor speed is 2,400 RPM + / - 200 RPM when engine is at full RPM.
•
Viewed from the operator zone, the cutter drum rotates in a clockwise direction. This rotation pulls
branches into the chipper.
•
Always wear protective gloves and safety glasses when operating the chipper.
•
If it becomes necessary to push material into the chipper's hopper, only use a wooden stick, never
hands or anything made of steel.
•
Always keep your hands out of the chipper hopper.
•
Keep area of discharge clear of people, animals, buildings, glass or anything else that will
obstruct clear discharge, cause injury or damage. Wind can also change discharge direction,
so be aware.
Read the safety instructions in this user manual before using the equipment,
P. Lindberg A/S
Tlf: 70212626
22
Sdr. Ringvej 1
DK-6600 Vejen
MAN 9068995 EN V1
www.p-lindberg.dk
e-mail: salg@p-lindberg.dk