Instructions For Use; Fuel And Oil; Checking And Topping Up Oil; Procedure For Checking Oil - P.Lindberg 9068995 Manual

INSTRUCTIONS FOR USE

Always remember to check the oil level before starting!
The engine is delivered without oil. Fill with 10W30 oil before starting the engine. Make
sure that no dirt or impurities get into the engine when checking or topping up the oil.
Use good quality oil, do not use special additives.

FUEL AND OIL

CHECKING AND TOPPING UP OIL

• Check the oil level before starting the engine.
• Check the oil level daily or after every 8 hours.
• Keep the oil level at FULL.
• Do not overfill.

PROCEDURE FOR CHECKING OIL

1. Check the oil level before starting the engine.
2. Place the engine in a level position. Clean around the oil filler and dipstick.
3. Push the dipstick back in and remove it to check the oil level.
4. Remove the oil filler cap. Slowly pour in oil.
5. Fill up to the FULL mark on the dipstick - check again.
6. Reinsert the dipstick firmly.

FUEL

Use clean, fresh, regular unleaded petrol according to the engine manual.

ADDING FUEL

•
Fill the tank outdoors or in a well-ventilated area, away from sparks, open flames, pilot lights, heat
and other sources of ignition.
•
If fuel is spilled, wait for it to evaporate before starting the engine.
•
Switch off the engine and allow it to cool down for at least 2 minutes before removing the petrol
cap.
•
Remove the cap. Fill the tank to approximately 38 mm below the top of the neck to allow the fuel to
expand. Be careful not to overfill. Replace cap cover before starting.
P. Lindberg A/S
Tlf: 70212626
20
Sdr. Ringvej 1
DK-6600 Vejen
MAN 9068995 EN V1
www.p-lindberg.dk
e-mail: salg@p-lindberg.dk