Start-Up; Configuration Options For Start-Up; Base Settings - Burkert AE3363 Quick Start Manual

Type 3363, 3364, 3365
9

START-UP

WARNING!
Risk of injury due to improper operation.
Improper operation may result in injuries as well as damage to
the device and the surrounding area.
▶ The operating personnel must know and understand the
contents of the Operating Instructions.
▶ The safety instructions must be followed and the device
used only as intended.
▶ Only adequately trained personnel may start up the system/
device.
9.1

Configuration options for start-up

• Configuration using the "Bürkert Communicator" software on
PC or tablet.
This method of configuration is possible on all device types and
device models.
The PC software Bürkert Communicator can be down-
loaded free of charge from the Bürkert website.
This requires the USB-büS-Interface set, which is
available as an accessory.
Communication is performed via the device's büS service
interface.
To avoid damage to the device, only use the power
supply unit supplied in the USB-büS-interface set.
Start-up
• Configuration on display of device (optional)
Only possible on devices with display module.
• Adjust the position control with 2 capacitive buttons in the
device
Only possible for devices without display module.
9.2

Base settings

A start-up wizard that provides step-by-step guidance
through the base settings is available for Bürkert Commu-
nicator and the display.
(Configuration area →
Process controller → START-UP)
9.2.1 Base settings for position control
Type of base setting
(observe sequence)
1. Set the safety position
Position control adjustment
2.
AG2: see chapter "9.4"
AG3: see chapter "9.5"
Set standard signal for set-point
3.
position
4. Set AUTOMATIC operating state MANUAL
Tab. 18: Base settings for position control
english
Position controller or
Factory default setting
Close
-
Signal type analogue: 4...20 mA
Gateway: Specified by fieldbus
39