Start-Up; Safety Instructions; Before Start-Up; Configuration Options For Start-Up - Burkert 3361 Operating Instructions Manual

Types 3360 and 3361

Start-up

11 START-UP
11.1

Safety instructions

WARNING!
Risk of injury due to improper operation.
Improper operation may result in injuries as well as damage to the device and the surrounding area.
▶ The operating personnel must know and understand the contents of the operating instructions.
▶ The safety instructions and the intended use must be observed.
▶ Only adequately trained personnel may start up the system/device.
11.2

Before start-up

NOTE!
Consider for devices requiring disassembly for installation.
If the actuator is disassembled, X.TUNE function must be carried out again before start-up. See chapter
"11.6 Adjustment of position controller – execute X.TUNE".
11.3

Configuration options for start-up

• Configuration with the Bürkert Communicator software on PC
This type of configuration is possible for all device types and device variants.
The Bürkert Communicator software can be downloaded free of charge from the Bürkert website.
It requires the USB-büS-Interface set available as an accessory.
Communication is performed via the device's büS service interface.
• Configuration on display of device (optional)
Only possible on devices with display module.
• Use two capacitive buttons in device to adjust position control (X.TUNE function)
Only possible on devices without display module.
11.4

Base settings

A start-up wizard that provides step-by-step guidance through the base settings is available for
Bürkert Communicator and the display.
(Configuration area → Position controller or
Process controller → START-UP)
english
73