Start-Up; Safety Instructions; Configuration Options For Start-Up; Base Settings - Burkert 3363 Operating Instructions Manual

11

START-UP

11.1

Safety instructions

WARNING!
Risk of injury due to improper operation.
Improper operation may result in injuries as well as damage to the device and the surrounding area.
▶ The operating personnel must know and understand the contents of the operating instructions.
▶ The safety instructions must be followed and the device used only as intended.
▶ Only adequately trained personnel may start up the system/device.
11.2

Configuration options for start-up

• Configuration with the Bürkert Communicator software on PC
This type of configuration is possible for all device types and device variants.
The PC software Bürkert Communicator can be downloaded free of charge from the Bürkert website.
It requires the USB-büS-Interface available as an accessory.
Communication is performed via the device's büS service interface.
• Configuration on display of device (optional)
Only possible on devices with display module.
• Use two capacitive buttons in device to adjust position control (function M.Q0-TUNE)
Only possible on devices without display module.
11.3

Base settings

A start-up wizard that provides step-by-step guidance through the base settings is available for
Bürkert Communicator and the display.
(Configuration area →
Process controller
11.3.1 Base settings for position control
Type of base setting (observe sequence)
1. Set the safety position
Adjustment of position control
2.
(Function M.Q0.TUNE)
3. Set standard signal for set-point position
4. Set AUTOMATIC operating state
Tab. 39: Overview: base settings for position control
80
Positioner or
→ START-UP)
English
Typ 3363, 3364, 3365
Start-up
Factory default setting
Close/open (dependent on device variant)
_
Signal type analogue: 4...20 mA
Gateway: Specified by fieldbus
MANUAL