Table of Contents
Advertisement
Installation Guide Linear Rotary Motors
5.4 Connecting the Drive to the Motor
The following diagram shows the connection of the linear motor with the LinMot Drive.
5.5 Pneumatic Air Connection
M5 x 12
The PR01-52-SSCH Motors are optionally (Designation with « L » suffix) equipped with an air connection. At
the rear of the motor, above the electrical connectors, there is a pneumatic push-in fitting (internal hexagon
M5) for a Ø 4 mm hose. Inside the motor, a Ø 4 mm air hose is laid along the rotating shaft, which has a
continuous hole diameter of Ø 2.5 mm. This enables the user to implement pneumatic applications with an
operating pressure of max. 6 bar. In the case of vacuum application, it is recommended to use a unit with
sufficient power, as experience has shown that all air coupling points generate small losses.
The specifications of the connections are shown in the drawing above.
NTI AG / LinMot
PR01-52-SSCH
ENG
Steckverschraubung
Internal-hexagon M5
Page 15 / 30
Advertisement
Table of Contents
