Disabling The Configuration Report At Startup; Manually Setting The Ethernet Interface Speed; Assigning A Network Address - Xerox ColorQube 9301 System Administrator Manual

Initial Setup

Disabling the Configuration Report at Startup

1. In CentreWare Internet Services, click Properties > Services.
2. Click Printing > General.
3. Under Configuration Report, clear Print at Power on.
Click Apply to save the new settings or Undo to retain the previous settings.
4.

Manually Setting the Ethernet Interface Speed

The Ethernet interface on the printer automatically detects the speed of your network. Any auto-sensing
devices connected to the network, such as a hub, do not always detect the correct speed. Refer to the
configuration report to ensure that the printer detects the correct network speed.
At the printer control panel, press the Machine Status button, then touch the Tools tab.
1.
2. Touch Network Settings > Advanced Settings.
3. When the warning message appears, touch Continue.
Touch Ethernet Physical Media.
4.
5. Select the speed to match the speed of your hub or switch.
Touch Save, then touch Close.
6.

Assigning a Network Address

The printer automatically acquires a network address from a DHCP server by default. To assign a static IP
address, configure DNS server settings, or configure other TCP/IP settings, see
16 ColorQube 9301/9302/9303 Multifunction Printer
System Administrator Guide
IP on page 25.