Table of Contents
Advertisement
3-6E
3.5
OPERATING
POSITION
OF THE INSTRUMENT
The oscifloscope may be used in the following positions:
-horizontally on its bottom feet;
-on the carrying handle in various sloping positions.
The available oscilloscope angles with respect to the working surface can be selected after
depressing the push-butions in the brackets of
the carrying handle and turning.
The characteristics given in Chapter 6 are fully guaranteed for all the above-mentioned
positions.
ATTENTION:
Ensure that the fan hole in the rear cover and the holes in the cover are free
from obstruction, for correct functioning of the fan.
Do not position the oscilloscope on any surface which radiates heal, or in
direct sunlight.
Figure 3.5 Carrying handie rotation and sloping positions.
3.6
IEEE 488/RS232-C INTERFACE OPTION PM 8956
tf your oscilloscope is equipped with an option containing the IEEE 488 bus interface and an
RS232-C interface, it can be used in an IEEE bus system configuration and in a system for serial
communication.
For installation instructions, see information delivered with this option.
See also section 8.2 "OPTIONAL ACCESSORIES".
Advertisement
Chapters
Table of Contents
