Philips PM3320 Operating Manual page 112

4-92E
4.3 DETAILED OPERATING INFORMATION
4.3.1 Introduction
Before switching on, ensure that the oscilloscope has been installed in accordance with the
instructions given in Chapter 3 and that the various precautions outlined have been observed.
The following sections give more detailed information regarding the specific functions of the
instrumentit also gives a suitable starting routine before any measurements are made.
Before reading this chapter, it is recommended that Chapter 4.2.
Explanation of controls and sockets is first read.
This detailed information is especially useful for those operators who are not familiar with this
type of oscilloscope.
The following subjects are described:
Start up procedure 4.3.2
Use of internal registers 43.3
Use of probes 43.4
Input coupling AC, 0, DC 43.5
OFFSET and SHIFT 4.3.6
Added mode and common-mode measurements 4.3.7
Triggering 43.8
Trigger delay 4.3.9
Time-base modes 4.3.10
MIN / MAX-mode 43.11
AVERAGE-mode 43.12
Horizontal magnifier 4.3.13
Vertical magnifier 4.3.14
A versus B mode 4.3.15
Analog PLOT-mode 4.3.16