Setting The Boundaries Of The Projected Image; Calibrating The Image - Christie H Series User Manual

6. To focus the image, adjust the Focus slider.
Christie recommends the default (minimum value) for focus.
7. Select Advance.
8. To make the image solid white, select Auto Tune.
If Auto Tune cannot find the best value, adjust the Exposure, Brightness, Gain, and
Contrast parameters to make the image clear.
9. To close the window when the image is clear, select Exit.

Setting the boundaries of the projected image

Set the boundaries of the projected image so the image is displayed within the limits of the webcam
projection.
1. To open the Boundary Setting page, from the Auto Warp homepage, select Boundary.
2. To set the grid number, adjust the Grid Number slider.
Christie recommends setting the grid to 2 x 2.
3. Select the warping mode: Curve or Linear.
4. Move the cursor to the blue circle on the image and select.
The point turns to a yellow circle.
5. Drag the boundary to the required location, making sure the two solid yellow lines are within
the overlap area.
6. To fine tune the boundary, adjust the grid number slider to a larger number.
7. Repeat steps 4 and 5.
8. Under Pattern, choose a suitable pattern.
9. Magnify the image by scrolling the mouse or adjusting the Zoom setting.
10. To close the window, select Exit.
To reset to the default boundary configuration, select Reset Boundary.

Calibrating the image

Calibrate the image so it clearly fills the defined area.
1. To open the calibration page, from the Auto Warp homepage, select Calibration.
Calibration starts.
2. If the image is fine, close the application.
3. If the image is not as expected, to recalibrate the image, select Re-calibration.
a) Adjust the sharpness value until the white area is a full solid area.
b) When the image is as expected, select Next.
c) Adjust the sharpness value again until the white area is a full solid area.
d) Select Done.
Auto correction starts.
e) If the image is as expected, return to the Boundary page (on page 9) to compare the
image.
H Series, HS Series, GS Series, and Inspire Series User Guide–Auto Warp
020-102080-05 Rev. 1 (01-2024)
Copyright © 2024 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Auto blending solution
11