Setting Up The Camera; Setting The Boundaries Of The Projected Image; Calibrating The Image - Christie H Series User Manual

Setting up the camera

Set up the camera so the image appears clearly within the target image area.
1. To open the camera, from the Auto Warp homepage, select Camera.
2. From the Camera list, select Logitech HD Pro Webcam C920.
3. Select Open Camera.
4. To increase or decrease the magnification of the image so it fits within the image box, adjust
the Zoom slider.
5. To move the image, use the T+/- or P+/- controls .
6. To focus the image, adjust the Focus slider.
Christie recommends the default (minimum value) for focus.
7. Select Advance.
8. To make the image solid white, select Auto Tune.
If Auto Tune cannot find the best value, adjust the Exposure, Brightness, Gain, and
Contrast parameters to make the image clear.
9. To close the window when the image is clear, select Exit.

Setting the boundaries of the projected image

Set the boundaries of the projected image so the image is displayed within the limits of the webcam
projection.
1. To open the Boundary Setting page, from the Auto Warp homepage, select Boundary.
2. To set the grid number, adjust the Grid Number slider.
Christie recommends setting the grid to 2 x 2.
3. Select the warping mode: Curve or Linear.
4. Move the cursor to the blue circle on the image and select.
The point turns to a yellow circle.
5. Drag the boundary to the required location, making sure the two solid yellow lines are within
the overlap area.
6. To fine tune the boundary, adjust the grid number slider to a larger number.
7. Repeat steps 4 and 5.
8. Under Pattern, choose a suitable pattern.
9. Magnify the image by scrolling the mouse or adjusting the Zoom setting.
10. To close the window, select Exit.
To reset to the default boundary configuration, select Reset Boundary.

Calibrating the image

Calibrate the image so it clearly fills the defined area.
1. To open the calibration page, from the Auto Warp homepage, select Calibration.
H Series, HS Series, GS Series, and Inspire Series User Guide–Auto Warp
020-102080-05 Rev. 1 (01-2024)
Copyright © 2024 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Auto blending and stacking solution
14