Auto Blending And Stacking Solution; Configuring The Auto Blending And Stacking Solution - Christie H Series User Manual

Hide thumbs Also See for H Series:

Table of Contents

Auto blending and

stacking solution

When a user needs to project large content on the wall with sufficient output brightness, crop the

content into X number of parts, project them by Y units (Y > X), and use the blending function to

blend all of the projected images into a complete image.

Follow these steps to configure the stacking solution.

1. Set Stacking as the solution you want to configure (on page 13).

2. Set up the camera (on page 8) so it appears clearly in the target image area.

3. Set the boundaries (on page 9) of the projected image.

4. Perform calibration (on page 9) so the image clearly fills the target area.

Configuring the auto blending and stacking

solution

Select the auto blending and stacking solution when you want to project large content on the wall with

sufficient output brightness.

1. To open a new project, from the Auto Warp homepage, select New.

2. From the Solution mode screen, select Stacking & Blending.

3. Select Next.

4. Select the required resolution.

5. In the Layout field, select the type of blending.

•

Horizontal blending = 1 Row x 2 Column

•

Vertical blending = 2 Column x 1 Row

6. In the Stack No field, enter 2 for the stack number.

7. Under Network, double-click the IP address and modify the IP address as required.

8. Select Next.

9. Select Preview and check the image.

The blue line from the right image must exceed the yellow line from the left image. The yellow

line from the left image must exceed the blue line from the right image.

10. When the overlap area is correct, select OK.

H Series, HS Series, GS Series, and Inspire Series User Guide–Auto Warp

020-102080-05 Rev. 1 (01-2024)

If printed, please recycle this document after use.

Table of Contents