A.3.2.3
Inserting the converter into the SIMATIC Manager
Select your project in the
SIMATIC Manager and open
the "Insert single drive unit"
screen form by right clicking
on "Insert New
Object/SINAMICS".
There, under the tab "Drive
unit/bus address", as shown
in the diagram, select your
converter and under the tab
"General" (
PROFINET device name.
Exit the screen form with
OK.
The converter is now displayed in your project in the SIMATIC Manager.
A.3.2.4
Activate diagnostic messages via STEP 7
In HW Config, select the converter
Open by double-clicking on slot 0 in the
station window
for the network settings of the converter
and activate there in the parameter
tab as shown the standard alarms
SINAMICS G120C frequency converter
Operating Instructions, 03/2012, FW V4.5, A5E02999804B AB
⑦
) enter the
②
the properties window
①
Standard
③
④
.
Appendix
A.3 Application examples
325