Table - Siemens SINAMICS G120 Operating Instructions Manual

No.
65 hex
66 hex
68 hex
6A hex
6B hex
86 hex
87 hex
C8 hex
C9 hex
CC hex Change request not permitted (change is not permitted as the access code is not available)
Parameter number
Parameter numbers < 2000
Parameter numbers ≥ 2000

Table 8- 13

Parameter number
0000 ... 1999
2000 ... 3999
6000 ... 7999
8000 ... 9999
10000 ... 11999
20000 ... 21999
30000 ... 31999
SINAMICS G120C frequency converter
Operating Instructions, 03/2012, FW V4.5, A5E02999804B AB
Description
Parameter number is currently deactivated (depending on the mode of the converter)
Channel width is insufficient (communication channel is too small for response)
Illegal parameter value (parameter can only assume certain values)
Request not included / task is not supported. (The valid request identifications can be found
in table "Request identifications control → converter")
No change access for a controller that is enabled. (Operating status of the converter
prevents a parameter change)
Write access only for commissioning (p0010 = 15) (operating status of the converter
prevents a parameter change.)
Know-how protection active, access locked
Change request below the currently valid limit (change request to a value that lies within the
"absolute" limits, but is however below the currently valid lower limit)
Change request above the currently valid limit (change request to a value that lies within
the "absolute" limits, but is however above the currently valid upper limit, e.g. specified as a
result of the converter power rating)
PNU = parameter number.
Write the parameter number into the PNU (PKE bit 10 ... 0).
PNU = parameter number - offset.
Write the parameter number minus the offset into the PNU
(PKE bit 10 ... 0).
Write the offset in the page index (IND bit 7 ... 0).
Offset and page index of the parameter numbers
Offset Page index
Hex
0 0 hex
2000 80 hex
6000 90 hex
8000 20 hex
10000 A0 hex
20000 50 hex
30000 F0 hex
8.3 PROFIdrive profile for PROFIBUS and PROFINET
Bit 7 Bit 6 Bit 5 Bit 4
0 0 0
1 0 0
1 0 0
0 0 1
1 0 1
0 1 0
1 1 1
Configuring the fieldbus
Bit 3 Bit 2 Bit 1
0 0 0 0
0 0 0 0
1 0 0 0
0 0 0 0
0 0 0 0
1 0 0 0
1 0 0 0
Bit 0
0
0
0
0
0
0
0
101