Backing Up And Transferring Settings Using Starter - Siemens SINAMICS G120 Operating Instructions Manual

10.2

Backing up and transferring settings using STARTER

With the supply voltage switched on, you
can transfer the converter settings from
the converter to a PG/PC, or the data
from a PG/PC to the converter.
This requires you to have installed the
STARTER commissioning tool on your
PG/PC.
You will find additional information about STARTER in the section: Commissioning tools
(Page 18).
Procedure converter → PC/PG
● Go online with STARTER :
● Select the button "Download project to PG":
● To save the data in the PG, select the button:
● Go offline with STARTER :
Procedure PC/PG → Converter
The procedure depends on whether you also transfer settings of safety functions or not.
Converter without safety functions:
● Go online with STARTER :
● Select the button "Download project to target system":
● To save the data in the converter, select the "Copy RAM to ROM" button:
● Go offline with STARTER :
SINAMICS G120C frequency converter
Operating Instructions, 03/2012, FW V4.5, A5E02999804B AB
Data backup and series commissioning
10.2 Backing up and transferring settings using STARTER
.
.
.
.
.
.
.
.
255