Troubleshooting; Remote Interlock; System Warnings - EMS DOLORCLAST FT-245 Instructions For Use Manual

10. TROUBLESHOOTING

Ensure that the product and the accessories have been
used as specified in the instructions for use.
To improve our quality of service, please provide the
following information:
- Product reference number (REF)
- Serial number (SN)
- Software revision
- Product service history (for example, previous
issues or repairs)

10.1. REMOTE INTERLOCK

The FT-245 is equipped with a remote interlock jack
that can be used to trigger an alarm following an event
external to the system (Figure 20).
The correct functioning of the remote interlock system is
checked on a weekly basis by opening the access door to
the area protected by the system during laser delivery. If
everything works correctly, the device should immediately
stop the delivery, which can only be restarted once the
door has been closed and the machine has been reset.
If this does not occur, or if the alarm sounds when it
shouldn't, check the integrity of the entire system, paying
particular attention to the correct wiring of the connector,
which should be positioned correctly in the corresponding
jack, and visually check the integrity of the connection
leads and the system. If the problem persist, contact the
Technical Support department.
00_FB-1007_16_rev_C_DOLORCLAST High Power Laser_EMS.indb 19 00_FB-1007_16_rev_C_DOLORCLAST High Power Laser_EMS.indb 19
Figure 20

10.2. SYSTEM WARNINGS

In the event of a serious internal failure, the message
'system error' will appear and operation will be completely
blocked.
Figure 21
In such cases, the machine must be restarted by pressing
the 'Reboot system' button and, if the problem arises
again, the EMS support center must be contacted,
providing the code that will be shown in a video.
19
7/9/2021 9:53:32 AM 7/9/2021 9:53:32 AM