Table of Contents
Advertisement
Connecting
6.4 DVI connector
6.4
DVI connector
CAUTION
Make sure that the video source is set correctly
The monitor sends the correct settings to the video source via the DDC communication
interface. If you change these settings, the images will not be displayed correctly.
CAUTION
Do not kink the cables
The cables must not be kinked. The minimum bending radius of the cable is 30 mm.
CAUTION
Removal/insertion of cables: only if monitor is turned off
Only when the monitor is turned off may DVI cables, TDL modules, or the cables of the TDL
modules be inserted or removed.
The monitor receives digital DVI input signals and has two Dual Link DVI connectors (A and
B).
● Only use the Dual Link DVI cables specified by EIZO or the TDL3600-QL transmission
links available from EIZO.
The picture quality, noise immunity and radiated interference of the entire system depend
on cable quality and length.
● You must use a device tested in accordance with IEC 60601-1 or IEC 60950-1 to control
the monitor.
See also
Connector locations (Page 25)
28
RadiForce® LS560W
Instruction Manual, 04/2012, A5E10000920A-006
Advertisement
Table of Contents
