Device Connectors; Connector Locations - Eizo CuratOR LX1910 Instructions For Use Manual

NOTICE
Cable installation
Observe the following instructions:
• Only shielded cables are to be used for all signal connections.
• The connecting cables must not be kinked.
• The minimum bending radius of a connecting cable generally equals five times the ca-
ble diameter.
• Do not route signal cables and power cables next to one another. Otherwise, line power
subject to heavy interference could result in reversible pixel errors.
• The device must not share a line power supply with motors or valves (interference!).
• Externally connected cables can represent a trip hazard. Make sure that all incoming
cables are safely routed.
• If the device offers strain relief mechanisms for the cables, use them to prevent unin-
tended loosening of connected cables.

5.2 Device connectors

5.2.1 Connector locations

The connectors and the main switch are located on the back of the device.
NOTICE
Disconnecting from line power
The device is disconnected from line power by turning off the power switch.
• Make sure that the main switch is easily accessible.
Main switch
Grounding
Fig.: Rear view CuratOR LX1910
CuratOR LX1910
Instructions for Use, 08/2022
Connecting
5.2 Device connectors
Signal inputs
Type plate
17