Application planning
4.2 Distances and arrangement of units
Avoid reflections on the screen
The monitor has an anti-glare surface which is only effective if the screen is clean and
grease-free.
● Note the cleaning instructions (Page 37).
● Position the monitor so that no reflections appear on the screen.
The reflections can be caused by lights, windows, furniture with shiny surfaces, or light-
colored walls.
● To avoid reflections on the monitor: Only use non-dazzling reflector lights for the ceiling
lighting.
Change of environment
If brought from the cold into a warm environment, water may condense inside the unit. The
device may be damaged if it is switched on in this state.
● Wait until the condensed water has evaporated, including that inside the device, before
you switch it on. The warm-up procedure may last several hours.
See also
General safety notes (Page 8)
Cleaning (Page 37)
4.2
Distances and arrangement of units
Minimum distances from other devices and a wall
The monitor has a VESA-400 installation connection.
To ensure unimpeded access to the power switch:
● Ensure that the monitor is positioned at least 10 cm at the side and rear from a wall, and
15 cm from other equipment.
Sensitive panel surface: avoid shocks and impacts
The monitor, especially the panel surface, is sensitive to shock. An impact on the panel
surface can lead to total failure.
● Avoid such mechanical influences at all costs.
If the monitor is installed to be movable
make sure that the moved mass does not endanger persons or fittings.
18
RadiForce® LS560W
Instruction Manual, 04/2012, A5E10000920A-006