Avoidance Of Image Sticking - Eizo RadiForce LS560W Instruction Manual

Commissioning

7.3 Avoidance of image sticking

Switch on PC before the monitor
1. Switch on the PC.
2. Switching on the monitor.
If the connected signal can be displayed on the monitor, the operation LED will light
green.
See also
Troubleshooting (Page 39)
7.3 Avoidance of image sticking
● Use a screen saver function in order to reduce "image sticking" that may occur with TFT
displays.
● If the device is no longer required: Switch off the device.
● If the application permits a power saving mode, the device can be switched to this status:
Set the option in your application for switching the device to power saving mode.
Image sticking
Image sticking is an effect in which a faint image of the previous screen contents can be
seen after the display contents have changed. By using a screen saver with continuously
changing screen contents, an unnecessary long depiction of a single image on the screen
can be avoided.
See also
Troubleshooting (Page 39)
32
CAUTION
The operation LED does not light green after power has been switched on?
If the operation LED does not light green after the equipment has been switched on and
a video signal has been applied, check the system for basic connection and operating
errors before contacting service personnel.
RadiForce® LS560W
Instruction Manual, 04/2012, A5E10000920A-006