Table of Contents
Advertisement
7.4
Graphics controller settings
The monitor can be used as a high-end PC monitor without the large monitor system. The
monitor can be operated with any PC whose graphics card features two dual link outputs.
The graphics card must support a resolution of 3840 by 2160 in "stretched mode". The DVI
outputs must be operated in isochronous mode.
Control of the monitor with LMM56800 or LMM0802 Large Monitor Manager
No further parameter settings required
If the LMM56800 or LMM0802 Large Monitor Managers are used to control the
RadiForce® LS560W, no settings to the graphics card are necessary. All parameters are set
automatically by the Large Monitor Managers.
Control of the monitor without LMM56800 or LMM0802 Large Monitor Manager
Parameters need to be set
When the PC is switched on, the monitor properties are read out and the graphics card is
initialized accordingly. The graphics card must support DDC communication. After this
process, the monitor is recognized by Windows as a plug-and-play monitor. The EDID data
(Extended Display Identification Data) are transmitted to the graphics card via the DVI
cable's DDC channel.
1. To operate the monitor with the desired resolution, you must install a driver designed for
the graphics card in use.
2. Once the driver has been successfully installed, you can configure the resolution as
dictated by the driver and the operating system settings.
Note
Installation and parameterization of the graphics card
Please refer to the graphics card manufacturer's manual for detailed information about
installation and configuration of the graphics card.
7.5
Information on the display settings
All displays are optimally preset in the factory, meaning that changes are not usually
required.
Power management settings
Observe the instructions of the operating system manufacturer regarding the power
management settings. The monitor supports the "DVI DMPM mode" (Digital Monitor Power
Management), which can be used to save energy.
By means of DVI DMPM, the monitor can be switched off automatically, e.g. after 20
minutes.
RadiForce® LS560W
Instruction Manual, 04/2012, A5E10000920A-006
Commissioning
7.4 Graphics controller settings
33
Advertisement
Table of Contents
