Table of Contents
Advertisement
6 Initial startup
6.2 Installing the software
26
6.2
Installing the software
NOTICE
Initial installation without inEos X5
Perform the initial installation of the software without connecting inEos
X5.
The software requires the 2.00 firmware version of the license stick.
Update the firmware version if necessary. For additional information,
refer to the "License manager" section in the user manual inLab SW.
At least one inLab PC version 4.0.x with Hardware Upgrade Kit or an
inLab PC version 5.0.1 or newer is needed for the software. The latest
inLab PC version is always recommended.
Use the version of the license manager provided with this version to
install licenses from the license certificate provided.
NOTICE
Installation only with administrator rights
You must have administrator rights on the PC on which you want to
install the software!
Preparing the installation
ü The USB license stick firmware is available in at least version 2.00.
ü The PC is booted and all programs are closed.
1. Insert the USB stick into the corresponding USB port of the PC.
or
➢ Download the software from the Internet.
2. Execute the file "Setup.exe" .
Ä This installation program starts.
Installing the application
1. Select the language for the following installation and then press the
"Next" button.
2. Read the information on copyright carefully and then press the
"Next" button.
3. In the next step, select the language and application region for the
application and then press the "Next" button.
4. In the next step you have the option of defining another folder for
the installation of the application and, if necessary, an alternative
folder for the patient data folder.
Then press the "Next" button. The path to the patient data folder
can still be changed after the installation via the configuration menu.
Ä The application is now installed. This may take several minutes.
5. Following successful installation, press the "Start" button to
complete the installation and to start the application immediately
after this. At this point, you have the option to subscribe to a
Dentsply Sirona newsletter.
Tip: If you do not want to start the application immediately, remove
the tick from the "Start application directly" check box and then
press the "Exit" button.
Ä The installation program closes.
Dentsply Sirona
Operating Instructions inEos X5
64 17 096 D3586
D3586.201.01.16.02 2023-12
Advertisement
Table of Contents
