Control; Device Control; Device Functions - Salda SMARTY XP Mounting And Installation Instruction

7. CONTROL

7.1.

DEVICE CONTROL

Ventilation unit equipped with miniMCB control board can be controlled with remote controller, WEB interface or mobile app via MB-GATEWAY
and BMS (Building Management System). More information provided in the table below.
With MB-GATEWAY
Web interface
SALDA AIR mobile application
BMS over Modbus TCP/IP
BMS over BACnet TCP/IP
Ventilation unit equipped with S300 control board can be controlled with remote control panel, mobile app via WIFI and BMS (Building Manage-
ment System). More information provided in the table below.
With MB-GATEWAY
BMS over Modbus TCP/IP
7.2.

DEVICE FUNCTIONS

All miniMCB control boards are run by the same software with all functions included. Full function list and description you can find on the MCB/
miniMCB technical manual. However, operation and control of the device depends on the following factors:
1. Selected control interface (remote control panel, MB-GATEWAY, etc.). The selected interface affects access to the information and settings,
however, it does not affect the logic of control. Full access to the information and settings is available on ST-SA-Control, MB-GATEWAY WEB
application and SALDA AIR mobile application.
2. Unit configuration (internal/external components, sensors and control board settings).
Smarty S300 units have integrated efficient microprocessor-based Siemens S300 controller (full controller's function list and description you can
find on the Siemens S300 technical manual). All unit's active components are controlled by Siemens controller. It has a lot of functions that can
efficiently operate air handling unit. Users have access to the controller configuration where the control settings can be changed or new con-
trollable devices can be added to the air control system. Users can also connect to the controller and monitor unit's status or change preferred
environment settings.
Operation and control of the device depends on the following factors:
1. Selected control interface. The selected interface affects access to the information and settings, however, it does not affect the logic of the
control. Remote controller have access of only basic user functions. Full access to the unit's configuration settings is available on ABT Go mobile
application for installer and service users.
2. Unit configuration (internal/external components, sensors and controller settings).
For unit control instructions, refer to the operation manual of the existing control device.
30 | EN
Remote control panels
Stouch
ST-SA-Control
Remote control panels
POS8.4420
POS8.4440
BMS direct connection
Modbus RTU (RS485)
BMS direct connection
Modbus RTU (485)
BACnet IP
Wireless communication
MB-GATEWAY + WIFI router
Wireless communication
WIFI stick + mobile app
SMARTY v2023.2