External Co /Rh Sensors (Version 1.1 / 1.2); Room Co Transmitter Installation Recommendation - Salda SMARTY XP Mounting And Installation Instruction

By default, D1 digital input is configured as Smoke detector input and set to NO, if needed NC contact type, then it must be reconfigured. See
section "ACCESSORIES SETUP (VERSION S300)".
8.4. EXTERNAL CO /RH SENSORS (VERSION 1.1 / 1.2)
2
Smarty XP 1.1 / Smarty XV 1.1 units feature two connections for external CO
Sensors connection:
Smarty 3X V 1.1 and Smarty 4X V F2 1.1 come with the integrated RH sensor connected.
Smarty XP 1.2 / Smarty XV 1.2 units feature one connection for external CO
Sensors connection:
These sensors feature 3 functions: Supply RH, Extract RH and Extract CO
Supply RH transmitter shall be installed inside supply air duct.
Extract RH and Extract CO transmitters shall be installed inside extract air duct or room.
2
8.5. ROOM CO TRANSMITTER INSTALLATION RECOMMENDATION
2
max. 400m
If the duct CO transmitter is used, it must be installed in the extract air duct. To install duct transmitters, hole drilling tools
2
are required .
38 | EN
2
/RH (input 0-10VDC) sensors.
2
/RH (input 0-10VDC) sensors.
2
.
2
min. 60 cm
m
5 0 c
m i n .
SMARTY v2023.2