Unit Placing And Mounting Positioning Requirements - Salda SMARTY XP Mounting And Installation Instruction

• Do not connect the bends close to
branch of the air duct in the supply and exhaust air ducts must be 3xD, where D is the diameter of the air duct.
• It is recommended to use the brackets (accessories). This will reduce the vibration transmitted by the unit to the air duct system and environment.
• Sufficient space must be provided for opening the device door and filter covers.
• If the ventilation unit is a wall-mounted
admissible, we recommend α mounting the unit
the unit on the wall of the room where the level of noise is not significant.
• Ducts are connected to the unit in such
out maintenance, service and/or
The protective film is used to protect the unit during transportation. It is recommended to remove the film; otherwise, oxidation
signs may occur.
The condensate tube must be filled with water as indicated during the first start-up before every heating season!
α
Figure 5.5.1.
*The location of the condensate outlet for the specific product is indicated in the dimensional drawing
Figure 5.5.2. Smarty XV horizontal floor-mounting positions on floor
(W=400 mm)

5.5.1. UNIT PLACING AND MOUNTING POSITIONING REQUIREMENTS

H
H
Figure 5.5.1.1. Min. distance to open the door - 1,5xL; Min. distance to open the control box door - H > 400 mm.
SMARTY v2023.2
α
the connection flanges of the unit. The minimum distance of the straight air duct between the unit and the first
device, it may transmit noise vibrations to the premises. Though the level of noise generated by the fans is
at a distance of 400 mm from the nearest wall. Where this is not possible,
a way that they could be easily
repair works.
W
Smarty XP Ceiling-mounting positions (α>1
α
W
α
α
disassembled, and the coil
) (only for units with condensation heat exchanger)
o
Figure 5.5.3.
L
L
1,5xL
1,5xL
1,5xL
1,5xL
we recommend mounting
could be removed from the unit when carrying
α
W
Smarty XV ceiling-mounting positions
W
L
L
W
W
H
H
EN | 17