Fan Maintenance - Salda SMARTY XP Mounting And Installation Instruction
Source: salda.lt/en, vetter-lufttechnik.de
Hide thumbs
Also See for SMARTY XP:
- Mounting and installation instruction (48 pages) ,
- Mounting and installation instruction (60 pages)
Table of Contents
Advertisement
Figure 6.5.3.
Figure 6.5.5.
CAUTION: the heat exchanger cannot be used when the filters are removed!
6.6.
FAN MAINTENANCE
• Fan maintenance should be performed by experienced and trained staff only.
• The fan should be inspected and cleaned at least once per year.
• Observe staff safety regulations during
• The fans features a heavy-duty ball bearing design. The motor is completely sealed and free of maintenance.
• Detach the fan from the unit.
• The impeller should be particularly checked for built-up material or debris that may cause an imbalance.
accelerated wear on
the
motor bearings and
• Clean
the
impeller and inside
• Do not use high-pressure cleaners,
• Do not plunge the motor
in
any fluid while cleaning the impeller. Make sure the impeller's balance weights are
• Make sure the impeller is free of any obstacles.
• Install the fan back into the unit. Connect fan power and control signals.
• In case the
fan does
not automatically start up or stop
by the pressure in the system (when pressure switches are connected). In case of any fault in the fan motor, a notice will appear on the control
panel.
Prior to commencing any maintenance or repair works, make sure the unit is disconnected from the power source.
SMARTY XP (version 1.1 / 1.2):
• Remove the fan connectors from the control board. Supply air fan connects to X15, X2, X4 connectors. Extract air fan connects to X16, X2, X4
connectors.
SMARTY XV (version 1.1 / 1.2):
• Remove the fans connectors from the control board or fan housing. Supply air fan connects to control board's X15, X2, X4 connectors. Extract air
fan connects to control board's X16, X2, X4 connectors. Smarty 4X V F2 fans can be disconnected by unplugging X32, X33 connectors located
on the fans housing.
NOTE:
• X2 and X4 are the same for both fans.
24
| EN
Smarty 3X P / 4X P
Smarty 2X V
the
maintenance and
cause
vibration.
the
housing with
a
mild detergent
abrasive materials and
sharp tools or caustic solvents that may scratch or damage the housing and impeller.
after
maintenance, contact the manufacturer.
Figure 6.5.4.
Figure 6.5.6.
repair
works.
and a damp
soft cloth.
Smarty 3X P E / 4X P E
Smarty 3X V / 4X V
An
excessive imbalance may lead to
in
place.
The
malfunction of the fan can be identified
SMARTY v2023.2
Advertisement
Table of Contents
