Starting The Sicam Fsi Configurator User Interface - Siemens SICAM V01.00 Manual

SICAM FSI Configurator

5.5 Starting the SICAM FSI Configurator User Interface

5.5

Starting the SICAM FSI Configurator User Interface

SICAM FSI Configurator supports the following Web browsers:
•
Microsoft Internet Explorer 8.0 or higher
•
Google Chrome 10.0 or higher
•
Mozilla Firefox 45.0 or higher
NOTE
i
i
Siemens recommends using Google Chrome 10.0 or higher.
Before starting the SICAM FSI Configurator user interface, the following preconditions must be satisfied:
•
If the SICAM FSI is used for first time, complete the installation procedure.
For more information about installation procedures, refer to
•
Magnetic reset of SICAM FSI is performed.
For more information about magnetic reset, refer to
•
The connection between the SICAM FSI and the PC or laptop computer using USB is established.
NOTE
i i
The serial port remains disabled until a magnetic reset is performed after which the serial port is enabled.
This port remains enabled as long as there is communication. If there is no communication for 10 min, the
port is auto-disabled to secure from spurious noises. To enable the serial port, reset the device again by
magnet adaptor.
To start the SICAM FSI Configurator user interface, proceed as follows:
Double-click the SICAM FSI Configurator icon from the desktop.
²
Select the Com port from the list box.
²
[sc_fsiconfig_com3, 1, --_--]
Figure 5-13
NOTE
i
i
Click on Refresh button to update available COM ports for connection.
Click Connect.
²
84
Configurator Connection
3.3.1 Installation.
3.5.1 SICAM FSI V2.0 B-Sensor
SICAM, Fault Sensor Indicator V2.0 B-Sensor, Manual
E50417-H8940-C656-A1, Edition 08.2023
Commissioning.