Riso CV1200W User Manual page 69

Loca- Type Code
tion
2 A02
2 A04
5 A05
Possible cause
A master has not been
correctly wrapped around
the print drum (cylinder).
Master ejection has
failed.
A master jam has
occured in the master
disposal section.
Action
Caution
• The print drum (cylinder) consists of a lot of metallic
parts. Do not touch those parts more than necessary.
Your hand may be cut.
• When rotating the print drum (cylinder) during mainte-
nance, hold the outer edge of the print drum (cylinder).
Your hands may become dirty with ink if you press the
master wrapped around the print drum (cylinder).
• The clamp plate is open when you are pressing the
clamp plate release lever. When you release the lever,
the clamp plate closes. Take extreme care not to be
pinched, or your hand may be injured.
• When you remove the master from the print drum (cylin-
der), the ink is spread on the master. Take care not to
allow the master to come in contact with other parts or
objects.
1) Pull out the print drum (cylinder) and remove the master
from the drum (cylinder) by hand.
(A 72 "Removing the print drum (cylinder)")
2) Set the print drum (cylinder) again.
3) Press the [START] key.
Remove the master disposal box and remove the jammed
master.
(A 56 "Emptying the Master Disposal Box")
If you cannot remove the jammed master even after remov-
ing the master disposal box, open the master disposal unit
and remove the master.
BOnce you pull out the master disposal box,
make sure to empty it before placing it back
into position.
67
Chapter 9 Troubleshooting
9