Precautions For Use; Consumables - Riso CV1200W User Manual

10
• When the print drum (cylinder) is out
655mm
(25 25/32
inches)
The distance from the right side of the machine to the
right edge of the stand (desk, etc.) should be 10 cm
(3 15/16 inches) or less. If the distance is greater than
10 cm (3 15/16 inches), the stand will interfere with the
paper receiving tray and it will not be possible to set
the tray up correctly.
■ Installation location
• The installation location of this machine will be
determined in consultation with you during delivery.
• The installation location of the machine should be
fixed.
When you want to move this machine, consult your
dealer or authorized service representative.
• Do not install this machine in the locations listed
below. Failure to observe this precaution may result
in malfunction, failure, or accident.
– Locations with exposure to direct sunlight
and locations close to windows
(cover the windows with curtains if neces-
sary)
– Locations that are subject to sudden changes
in temperature
– Extremely hot and humid locations or cold and dry loca-
tions
– Locations exposed to fire or heat, direct cold air (e.g., air
conditioner), direct hot air (e.g., heater), or where heat is
transmitted
– Locations with poor permeability and ventilation
• Choose a location where this machine is
level when it is installed. (Levelness for
installation: 10 mm [13/32 inches] or less
both lengthwise and widthwise)
10cm (3 15/16 inches) or less
• The appropriate environment conditions
are as follows.
Temperature range: 15°C to 30°C (59°F to
86°F)
Humidity range: 40% to 70% (no conden-
sation)

Precautions for use

1255mm
(49 13/32
■ Power connection
inches)
• Be sure to plug in the power cord securely
to prevent poor contact in the power plug
section.
• Locate this machine near the electric out-
let.
■ Operations
• Do not turn off the power or unplug the power cord
during operation.
• Do not open covers or move this machine during
operation.
• Open and close covers gently.
• Do not put any heavy objects on this machine.
• Avoid excessive impact on this machine.
• This machine contains precision parts and drive
mechanisms. Perform only the procedures
described in this guide.

Consumables

• For the ink and master rolls, it is recommended to
use the products specified by RISO.
• Genuine RISO inks and master rolls are engineered
for maximum performance and maximum life, and
RISO equipment is designed to give excellent per-
formance when used with genuine RISO consum-
ables.
However, all consumables can and do deteriorate
over time. We recommend that you use ink and
master rolls as soon as possible after purchase, and
within 18 months of the date of manufacturing.
You can find the date of manufacturing on the ink
cartridge or the inside of master core.
RISO genuine consumables transmit information
regarding the age of the consumables that allows
the machine to make adjustment based on the age
of the consumables, e.g., time remaining until the
Use By date.
• Store the paper, master rolls, and ink cartridges
properly according to the instructions indicated on
each container.
• Do not store those parts in the locations listed below.
– Locations with exposure to direct sunlight
and locations close to windows
(cover the windows with curtains if neces-
sary)
– Locations that are subject to sudden changes
in temperature
– Extremely hot and humid locations or cold and dry loca-
tions