Riso CV1200W User Manual page 72

70
Chapter 9 Troubleshooting
Loca- Type
tion
6
-
6
4
2
■ E00-0000: Maintenance call error
Loca- Type
tion
-
-
■ F00-0000: Warning
If the code is not shown, press the [U] key.
Loca- Type
tion
2
-
6
Code Possible cause
D08 The master making unit
cover is open or is not set
correctly.
D13 The rear cover of this
machine is removed.
D17 An inappropriate master
roll is set.
The label at the opposite
side of the [ I ] mark of
the master core has been
peeled off or contami-
nated.
D23 The document feeder
cover is open or is not set
correctly.
D45 Ink from the ink cartridge
is not being supplied
appropriately.
Code Possible cause
E01 Low battery.
E02 Notifies user about the
need for a periodic
inspection.
Code Possible cause
F01 No master is attached to
the print drum (cylinder).
F05 An attempt is being made
to print a smaller number
of copies than the mini-
mum print quantity.
F50 The thermal print head is
too hot.
Action
Close the master making unit cover correctly.
Consult your dealer or authorized service representative.
Set an appropriate master roll in place.
BUse the master roll that is recommended by
RISO. If other master rolls are used, it may
result in malfunctions or problems.
The label attached to the opposite side of the [ I ] mark of
the master core contains the necessary information for
printing.
Set a master roll in place that contains a label that is not
bent or cut.
(A 52 "Setting the Master Roll")
Close the document feeder cover correctly.
The ink cartridge may have not been installed properly.
Remove the ink cartridge and set it again.
(A 54 "Replacing the Ink Cartridge")
Action
Consult your dealer or authorized service representative for
battery replacement.
Consult your dealer or authorized service representative for
periodic inspection.
Action
Perform master making.
BIf you leave the print drum (cylinder) with no
master attached, the print drum (cylinder) will
dry, and this situation may result in malfunc-
tions. Be sure to perform master making or
[CONFIDENTIAL]
to the print drum (cylinder).
Enter a value that is larger than the value that is specified in
[Minimum Print Q'ty] (A
Wait for the thermal print head to cool down.
Press the [RESET] key to erase the warning message.
(A 43) and load a master on
47) under [Custom Setting Mode].