Table of Contents
Advertisement
ATX165SL/SLE
Gently set the stage on a smooth, flat, and clean surface. Use compressed nitrogen or clean, dry, oil-
free air to remove any dust or debris that has collected during shipping.
Before you operate the stage, let it stabilize at room temperature for at least 12 hours. This will
ensure that all of the alignments, preloads, and tolerances are the same as they were when they
were tested at Aerotech.
Each stage has a label listing the system part number and serial number. These numbers contain
information necessary for maintenance or system hardware and software updates. Locate this label
and record the information for later reference.
Lifting Features
The ATX165SL/SLE has two lifting options: lifting handles (-LF1) and hoist rings (-LF2). The lifting
hardware must be removed before the stage can be operated. These options are not available with
the foldback version of the stage.
Figure 3:
Lifting Features
Storage
Store the stage in the original shipping container. If the original packaging included ESD protective
packaging, make sure to store the stage in it. The storage location must be dry, free of dust, free of
vibrations, and flat.
Refer to
Section 1.1. Environmental Specifications
14
Hardware Manual
www.aerotech.com
Advertisement
Table of Contents
