Table of Contents
Advertisement
Stellar FZ-1000 Fazer
Manual Operation
To set up the device, follow the steps below:
Fill the tank (Fluid Tank Capacity 4 L). See 6.3. Filling the Tank on pages 21–22 for more information.
Connect the power cable before supplying power to the device. See 4.5. Connecting to Power
Supply on page 16 for more information.
Set the ON/OFF switch (14) to ON.
Wait for the device to heat up. This will take a maximum of 3 minutes.
When the device is not 100 % heated you cannot view the menu or change the settings.
To operate the device manually as a stand-alone device:
●
Adjust the output volume in Output Vol menu. See 6.7.4.2. Output Volume on page 27 for more
information.
●
Adjust the fan speed. See 6.7.4.3. Fan Speed on page 27 for more information.
●
Adjust the interval volume in Interval menu. See 6.7.4.4. Interval on page 27 for more information.
●
Adjust the duration volume in Duration menu. See 6.7.4.5. Duration on page 27 for more information.
Notes:
●
You cannot constantly fog @100 % until the tank is empty.
In order to constantly fog, you have to adjust the output volume to 40 %. Only then will the device
keep fogging until the tank is completely empty.
●
Manual operation with the control panel on the device always has priority over the remote control
Control Panel (Device)
●
Use the START / PAUSE button to start/pause your fog operation.
●
Use the UP and DOWN buttons to increase/decrease numeric values.
●
Use the MENU button to navigate through the menus.
Product code: 61114
A) LCD display
B)
Start / Pause button
C) Down button
D) Up button
E)
Menu button
Fig. 20
25
Advertisement
Table of Contents
