Safety; Safety Compliance; Acoustic Statement (European Machinery Directive); General Safety Notices - Keysight S9165A Getting Started Manual

Safety & Environmental Information

Safety

Safety

This product has been designed and tested in accordance with accepted
industry standards, and has been supplied in a safe condition.The
documentation contains information and warnings that must be followed by
the user to ensure safe operation and to maintain the product in a safe
condition.

Safety compliance

This product complies with the essential requirements of the European LVD
(Low Voltage Directive) as well as current editions of the following standards
(dates and editions are cited in the Declaration of Conformity):
— IEC/EN 61010-1

Acoustic statement (European Machinery Directive)

Acoustic noise emission
LpA <70 dB
Operator position
Normal operation mode per ISO 7779

General safety notices

Getting Started Guide
If this product is not used as specified, the protection provided by the
equipment could be impaired. This product must be used in a normal condition
(in which all means for protection are intact) only.
This is a Safety Protection Class I Product (provided with a protective earthing
ground incorporated in the power cord). The mains plug shall only be inserted in
a socket outlet provided with a protective earth contact. Any interruption of the
protective conductor inside or outside of the product is likely to make the
product dangerous. Intentional interruption is prohibited.
This product is designed for use in INSTALLATION CATEGORY II and
POLLUTION DEGREE 2.
This product is designed for indoor use only and does not support
hot-swapping of modules; for example, inserting and removing modules with
the chassis powered up. Before installing modules in or removing modules
from the chassis, power down the chassis, but leave the power cord connected
to the AC Mains because it serves as a ground and helps protect the chassis
and modules from electrostatic damage.
9