Table of Contents
Advertisement
Safety & Environmental Information
Protecting against electrostatic discharge
Protecting against electrostatic discharge
Shipping materials and ESD
Keysight's chassis and instrument modules are shipped in materials which
prevent static electricity damage. These instruments should only be removed
from the packaging in an anti-static area, ensuring that correct anti-static
precautions are taken. Store all modules in anti-static envelopes when not
installed.
Test equipment and ESD
To help reduce ESD damage that can occur while using test equipment:
•
•
•
•
•
•
•
Additional information about ESD
For more information about ESD and how to prevent ESD damage, contact the
Electrostatic Discharge Association (http://www.esda.org). The ESD standards
developed by this agency are sanctioned by the American National Standards
Institute (ANSI).
16
Electrostatic discharge (ESD) can damage or destroy electronic components
(the possibility of unseen damage caused by ESD is present whenever
components are transported, stored, or used).
Do not use these first three techniques when working on circuitry with a voltage
potential greater than 500 volts.
Before connecting any coaxial cable to a test set connector for the first time
each day, momentarily short the center and outer conductors of the cable
together.
Personnel should be grounded with a 1 MΩ resistor-isolated wrist-strap
before touching the center pin of any connector and before removing any
assembly from the test set.
Be sure that all instruments are properly earth-grounded to prevent
build-up of static charge.
Perform work on all components or assemblies at a static-safe workstation.
Keep static-generating materials at least one meter away from all
components.
Store or transport components in static-shielding containers.
Always handle printed circuit board assemblies by the edges. This reduces
the possibility of ESD damage to components and prevent contamination of
exposed plating.
Getting Started Guide
Advertisement
Table of Contents
