Configuration Tool - Keysight S9165A Getting Started Manual

Quick Start
Turn-on Procedure

Configuration Tool

To configure the S9165A, run this application:
Windows Start > Keysight S91x0A > Configuration Tool
Figure 2-7 Using the Configuration Tool
Normally, this will already be correctly configured upon delivery. However, you
will need to check these settings again after a software updgrade which affects
the Service Manager application, and also after changes to the connected
hardware (for example, adding more RRHs).
— Base Product should be set to S9165A
— Number of RRHs should be set to the actual number of RRH units used
— Measurement Type should be set to SISO
— Service Connection Type should be set to Any
Click Configure. If the Configuration Successful! message appears, the
S9165A will be configured correctly after the next S9165A boot-up, or the next
time you click Restart Services on the Service Manager window. (However, if
you have changed the hardware connections to RRHs, this restart or reboot
should wait until the procedure described under
on page 29
26
has been completed.)
The Configuration Tool will need to be used again later, whenever there is a
system hardware change that alters the number of RRHs used.
"USB Channel Assignments"
Getting Started Guide