Table of Contents
Advertisement
AUTODOME 7100i│AUTODOME 7100i IR
9.
10. Tighten the top cap screws.
11. Tighten the screws to 10-12 Nm.
12. Apply power.
13. Remove the protective plastic sheet from the bubble. Installation is complete.
9.1
Installing a pipe mount onto a NDA-U-RMT with grounded
conduit
Note: When installing the NDA-U-RMT mount, electrically grounded, liquid tight metal
conduit must be used with extra grounding.
1.
2.
Bosch Security Systems
Tilt the camera until you connect the camera to the mount.
Make ground wire using a 12 AWG stranded wire that is soldered to a 3/8-inch (9.5
mm) ring terminal on one end and is bare copper on the other end. Note: The length of
the wire should be 150 to 200 mm (6 to 8 inches) long.
Add the 3/8-inch (9.5 mm) flat washer, ring terminal of the custom ground wire and the
3/8-inch (9.5 mm) split washer to the bottommost bolt on the NDA-U-RMT.
Installation Manual
Installing a pipe mount | en
2023-09-29 | V06 | F.01U.410.315
41
Advertisement
Table of Contents
