Table of Contents
Advertisement
AUTODOME 7100i│AUTODOME 7100i IR
Power disconnect - Units have power supplied to the unit whenever the power cord is
inserted into the power source, or when IEEE 802.3bt, type 3/4 (60W/90W) power is
provided over the Ethernet Cat5e/Cat6e cable. The power cord is the main power
disconnect device for switching off the voltage for all units. When IEEE 802.3bt, type 3/4
(60W/90W) is used to power the unit, the power is provided over the Ethernet cable, which
is then the main power disconnect device for switching off the voltage for all units.
Power lines - Do not locate the camera near overhead power lines, power circuits, or
electrical lights, nor where it may contact such power lines, circuits, or lights.
Damage requiring service - Unplug the device from the main AC/DC/PoE power source and
refer servicing to qualified service personnel when any damage to the equipment has
occurred, such as:
–
–
–
–
–
–
–
Servicing - Do not attempt to service this device yourself. Refer all servicing to qualified
service personnel.
This device has no user-serviceable internal parts.
FCC information
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
Intentional or unintentional modifications, not expressly approved by the party responsible
for compliance, shall not be made. Any such modifications could void the user's authority to
operate the equipment.
Notice!
i
This is a class A product. In a domestic environment this product may cause radio
interference, in which case the user may be required to take adequate measures.
FCC suppliers Declaration of Conformity
NDP‑7602‑Z40
NDP‑7602‑Z40L
NDP-7604-Z12L
NDP‑7602‑Z40-CA
NDP‑7602‑Z40L-CA
Bosch Security Systems
the power supply cord or plug is damaged;
exposure to moisture, water, and/or inclement weather (rain, snow, etc.);
liquid has been spilled into or on the device;
an object has fallen into the device;
the device has been dropped or its enclosure or the equipment cabinet in which it is
located is damaged;
the device exhibits a distinct change in performance;
the device does not operate normally when the user follows the operating instructions
correctly.
PTZ 2MP HDR 40x IP66 pendant
PTZ 2MP HDR 40x IP66 pendant IR
PTZ 8MP 12x IP66 pendant IR
PTZ 2MP HDR 40x IP66 pendant
PTZ 2MP HDR 40x IP66 pendant IR
Installation Manual
Safety | en
2023-09-29 | V06 | F.01U.410.315
9
Advertisement
Table of Contents
