Table of Contents
Advertisement
AUTODOME 7100i│AUTODOME 7100i IR
7.
8.
Warning!
Make sure that you connect the outgoing power supply wires to the P107 connectors (pin
!
4: 24VAC Line, and pin 5: 24VAC Neutral). Power supply fuse XF103 can handle a higher
amperage (3.15 A) than fuse XF102 (2.0A).
9.
10. Route the Ethernet cable through the points mentioned in the list that follows, in
11. Connect the ground wire attached to the arm mount to the metal spade shown in
Bosch Security Systems
Connect the second wire to pin 4 (24VAC Line) connector. (Note: the 3.15A fuse is in
this line).
Connect the third wire to pin 3 (Earth Ground) connector.
For the AUTODOME 7100i non-IR model (NDP-7602-Z40), complete the three substeps
that follow, and then proceed to further steps. For IR models, skip to the next step.
a. Route the 24 VAC outgoing power supply wires to the camera through the wall arm.
b. Cut and trim the 24 VAC power with sufficient slack to reach their connector
terminal X105 in the camera, but not so long as to be pinched by or to obstruct closing
the cover door.
c. Attach the 24VAC lines to AUTODOME 7100i User Interface connector X105, as
illustrated below.
sequence:
a. From the User Interface connector X104 in the arm mount (as shown below)
b. Through the arm to the PSU box.
c. Out 3/4 in. (20mm) NPS metal conduit fitting in the PSU box
d. Through electrically grounded, liquid tight metal conduit
e. To the computer.
Note: Use proper grommets to guarantee an IP66 rating.
Refer to Tools Required, page 14 for a list of the appropriate types of Ethernet cable to
use.
number 5 of Figure 2 of this subchapter to electrically connect the arm mount to the
power supply housing.
Installation Manual
Connection | en
2023-09-29 | V06 | F.01U.410.315
57
Advertisement
Table of Contents
